7.1

Table Of Contents

947

Record to Tape

3: Start Recording

If everything is set correctly, click Record.

 In Insert and Assemble mode, the recorder now cues the tape to the Sequence’s starting point on

the Timeline or to the specified Mark-In and, following a brief preroll, starts to record.

 In Dump To Tape mode, the recorder immediately starts recording at the current tape position;

the Sequence is output directly.

 In the case of MPEG2 output formats, the MPEG2 stream is rendered before recording begins.

 Recording stops when the end of the Sequence or a Mark-Out is reached.

For Insert editing, you need a striped tape (a tape that contains timecode information; see below). This is

not necessary if you select D ump To Tap e or Assemble.

You can monitor the process in the video inlay. Click All Stop to interrupt the process.