2022.x

Using Clip Volume and Pan Mode
728
6. (Option) If you are working with a stereo track, click the Stereo Link button if you want to link
the two Pan controls so that when you move one control the other moves correspondingly. You
can also click the Stereo Mirror button so that the two Pan controls mirror each other as you
adjust them.
7. Drag the Pan Location cursor to pan the track. The location of the Pan Location cursor
determines the pan position of the signal. For example, to pan something to the left rear speaker,
move the Pan Location cursor to the lower-left corner of the grid.
You can snap the Pan Location cursor to one speaker position by double-clicking a speaker icon.
This pans the audio fully to that speaker position. For example, if you click the upper left speaker
icon, the Pan Location cursor moves to the upper left corner of the grid and pans the audio fully
to the left speaker position.
8. When you finish adjusting pan with the Advanced Panner, click the Close button to return to the
Audio Mixer tool.
To pan using the Position controls:
1. Adjust the Front and Rear Position controls to set the trajectory line.
2. Rotate the Front/Rear Position control to pan along the trajectory. The Pan Location cursor is
constrained to the trajectory line.
3. If you want to change the trajectory angles, do one of the following:
t Drag either end point (Front or Rear) of the trajectory line.
t Adjust the Front or Rear Position controls.
4. If you want to change the current trajectory position (left-to-right) and retain its current angles,
drag the trajectory line (not its end points) to a new position.