6.0

Working with the Pan and Scan Effect
293
You cannot change the shape of the wire frame, which is determined by the Target aspect ratio.
Your Avid editing application maintains the shape during scaling.
To scale the wire frame, do one of the following:
t Click one of the wire frame’s handles, and drag it to the position you want.
t Click the triangular opener for the Scaling parameter category in the Effect Editor, and use
the slider controls to adjust the wire frame’s height and width.
To position the wire frame, do one of the following:
t Click inside the wire frame, and drag it to a new position.
Movement is restricted to the most important axis. For example, if you go from a wide
aspect ratio (16:9) to a narrow aspect ratio (4:3), you can drag the wire frame from side to
side. If you go from 4:3 to 16:9, you can drag the wire frame up and down.
t Shift-click inside the wire frame, and drag it to a new position.
You can move the wireframe in all directions.
t In the Position parameter category, adjust the wire frame’s horizontal and vertical Position
sliders.
Adjusting the Pan and Scan Effect
You might need to adjust Pan and Scan at different points throughout your sequence. The
following are some suggestions for adjusting Pan and Scan.
If your sequence needs few adjustments:
1. Click the Play button or the Play Loop button.
Play (left) and Play Loop (right) buttons