5.5

Using ExpertRender to Prepare Effects for a Digital Cut
1011
- The switch for internal timecode should be set to Regen (regenerate) or Slave Lock,
not Preset.
- After you record 15 to 30 seconds of timecode onto the record tape for jam syncing,
return the Local/Remote switch to Remote for deck control from within your Avid
editing application.
5. When you are ready to record, select additional options in the Digital Cut tool, as
described in “Recording a Digital Cut to Tape (Remote Mode)” on page 1016.
n
These switches are often located below the machine’s playback control buttons. For more
information, see the documentation provided with your record device.
Using ExpertRender to Prepare Effects for a
Digital Cut
Real-time effects might exceed the capabilities of your system and cause dropped frames
during a digital cut. You can choose to have your Avid editing application select and render
effects that might cause dropped frames.
To prepare effects for a digital cut:
1. Load the sequence you want to output.
2. Select the entire sequence or mark IN and OUT points for the area you want to output.
3. Open the ExpertRender dialog box by doing one of the following:
t Select Clip > ExpertRender In/Out.
t Right-click in the Timeline, and select ExpertRender In/Out.
The ExpertRender dialog box opens.