2.4

Marking In and Out Points
204
Note the following:
• If you do not have the appropriate access permissions on the asset in the Interplay
Production database, you cannot play the asset.
Access permissions are checked based on the shared user identity in the MediaCentral User
Management system. A users needs to have credentials linked to an Interplay Production
user for any Media Central UX systems the user accesses.
• You can play a remote asset, but you cannot add it to a sequence or create subclips. Controls
such as creating subclips or adding markers are disabled for remote assets.
• If you want to do more than play an asset, you need to have it delivered to your local
Interplay Production server. For more information, see “Delivering Assets and Media to a
Local Workgroup” on page 411
.
• You can share remote assets through links in the Messages pane. For more information, see
“Sending Messages” on page 386.
Marking In and Out Points
If you want to use only a portion of a clip, you can set an In and Out point in the clip, and then
add the edited clip to the sequence that accompanies your story. By default, In and Out points are
set at the first frame and last frame of a clip. You can mark In and Out points only in Asset mode.
The following illustration shows the buttons in the Media pane that you use with In and Out
points
To mark an In point:
1. Load a clip in the Media pane and navigate to the frame where you want to set the In point.
e r
q
y
w
t
1 Play In to Out 4 Mark Out
2 Go to In 5 Go to Out
3 Mark In 6 Review Out