2.1

Table Of Contents
Setting the Audio Mix
216
These settings are saved in the sequence and are used for mixdown and send-to-playback (STP).
If Mix Mode is set for Mono, panning is ignored and all tracks are mixed into a single track for
monitoring, which is played back in both output monitors (left and right). This setting is not
saved with the sequence. Panning as set in the Interplay Administrator is used for mixdown and
send-to-playback.
In the current release, the panning buttons are inactive, as shown in the following illustration.
n
For a procedure to override these defaults by using the application.properties file, see the Avid
MediaCentral Platform ReadMe. This override is global and applies to all Interplay folders.
n
Complex (uneditable) sequences created in Media Composer use panning as set in Media
Composer.
Setting the Audio Mix
You can set the audio mix for an asset or for a sequence. For an asset, up to 24 tracks are
monitored. You can select which tracks to monitor. For more information, see
“Audio
Monitoring for Assets and Basic Sequences” on page 206
. The audio mix is used for monitoring
only.
If the audio mix is set for stereo, panning controls are active.
n
See the MediaCentral ReadMe for possible limitations on the number of tracks you can monitor.