10.0

Core Avid Audio Plug-Ins
903
AIR Flanger (RTAS)
You can use the Flanger plug-in to apply a short modulating delay to the audio signal.
The following table lists the AIR Flanger plug-in parameters:
Rate Lets you select the duration, or frequency of the Low Frequency Oscillator (LFO). The duration
of one cycle of the LFO is measured in Steps.
Mix Lets you balance the amount of dry signal with the amount of wet (filtered) signal. At 50%, the
output includes equal amounts of dry and wet signal. At 0%, the output is all dry and at 100% it
is all wet.
Parameter Description
Parameter Description
Sync Synchronizes the modulation rate to the audio sequence tempo. When you enable Sync, you can
select a rhythmic subdivision or multiple of the beat for the Flanger modulation rate. When you
disable Sync, you can set the delay time in milliseconds independently of the sequence tempo.
Select from the following rhythmic values:
- 16 (sixteenth note)
- 8T (eighth-note triplet)
- 16D (dotted sixteenth-note)
- 8 (eighth note)
- 4T (quarter-note triplet)
- 8D (dotted eighth-note)
- 4 (quarter note)
- 2T (half-note triplet)
- 4D (dotted quarter-note)
- 2 (half note)
- 1T (whole-note triplet)
- 3/4 (dotted half note)
- 4/4 (whole note)
- 5/4 (five tied quarter notes)
- 6/4 (dotted whole note)
- 8/4 (double whole note)
• Depth — Lets you adjust the amount of modulation applied to the Delay time.