User's Manual

Introduction
Congratulations on the purchase of your new AVID MiniTracker Pro Reader. This
reader is capable of reading AVID and many other brands of electronic identification
tags using the FECAVA and ISO-FDX-B protocols.
Instructions
1.Power Button
Turn the reader ON by sliding the lower right hand button forward on the face of
the reader. When the reader is powered on, it will emit a double beep sound and
the LCD will display AVID/FEC/ISO. To turn the reader OFF, slide the button
back. (See Figure 1 below)
2. Read Button
Press the upper right button (marked “READ”) on the reader to put the reader into
the LOOKING mode. (See Figure 1 below) The LCD will display LOOKING.
When a microchip is found, the reader will emit two beep tones and display the
chip number on the LCD. If the Read button is released before finding a
microchip, the message NO ID FOUND will display on the LCD.
Battery
Compartment
AVID*123*456*789
Antenna
Reader
Figure 1
Copyright 2008 © Avid Identification Systems, Inc. 2
MTPro_ISO_Manual.doc - 11/3/2008