Music Mixer User Manual

Chapter 9: Management Sections 81
Actions Switch
The Actions switch displays the following commands:
Actions Switch (Page 1)
Prview (Preview) Puts Pro Tools in Preview mode
Punch Prview (Punch Preview) Executes the Punch Preview
command
Prview Suspnd (Preview Suspend) Suspends Preview mode
Captre (Capture) Executes the Capture command
Punch Captre (Punch Capture) Executes the Punch Capture
command
See “Previewing Automation” on page 108 and “Capturing
and Recalling Automation” on page 108 for more information
on these commands.
Actions Switch (Page 2)
Wrt To Start (Write To Start) Writes current automation val-
ues from the insertion point backward to the beginning of a
selection or track while performing an automation pass.
Wrt To Punch (Write To Punch Point) Writes current automa-
tion values back to the point where writing of automation be-
gan
Wrt To All (Write to All) Writes current automation values to
an entire selection or track while performing an automation
pass.
Wrt To End (Write to End) Writes current automation values
from the insertion point forward to the end of a selection or
track while performing an automation pass.
Wrt To Next (Write to Next Breakpoint) Writes current auto-
mation values from the insertion point forward to the next
automation breakpoint while performing an automation pass.
Snap Back Causes all Latch or Write enabled tracks to exit
their current automation pass and return instantly to the pre-
viously written automation levels. During playback, this com-
mand stops writing of automation without applying any Au-
toMatch ramping.
Actions Switch (Page 3)
Copy To Send Opens the Copy To Send dialog to allow copy-
ing of track control values to each selected track’s send (Edit >
Automation > Copy To Send).
Thin Auto (Thin Automation) Performs the Thin Automation
command. (Edt > Automation > Thin).
Colesc VCAAtm (Coalesce VCA Automation) Executes the
Track > Coalesce VCA Master Automation command
Colesc TrmAtm (Coalesce Trim Automation) Executes the
Track > Coalesce Trim Automation Command
Clear TrmAtm (Clear Trim Automation) Executes the Track >
Clear Trim Automation Command
Suspend TrmAtm (Suspend Trim Automation) Temporarily sus-
pends Trim automation to allow auditioning of Trim moves