Specifications

Artist Series and Pro Tools6
2 Launch Pro Tools.
3 Choose Setup > Peripherals, and click the Ethernet Controllers tab.
4 Select Enable EUCON.
5 Click OK. You do not need to configure any other Ethernet Controllers settings. These settings do
not apply to EUCON.
Pro Tools scans your system until it identifies attached EUCON-compatible hardware. When
Pro Tools finishes scanning your system, your controllers are ready to use with Pro Tools.
Using Multiple Units
Multiple Artist Series Units
Artist Series controllers can be combined to form larger, unified systems. For example, you can use
two Artist Mix units and an Artist Control simultaneously. Pro Tools will recognize all attached units
automatically.
Other Units
When EUCON is enabled in Pro Tools, the use of additional control surfaces is subject to the follow-
ing conditions:
 You can use the Surround Panner Option, as well as one USB/MIDI-based control surface at the
same time as EUCON. A MIDI control surface mirrors the first eight channels on your EUCON de-
vices.
 You cannot use another Ethernet-based control surface (such as an ICON worksurface or C|24 con-
trol surface) at the same time as EUCON.
Enabling EUCON in the Peripherals dialog
Using Artist Series controllers with Pro Tools version 8.x and lower utilized the HUI (MIDI Controller)
protocol. This is no longer necessary with Pro Tools 9.0 and higher.
Use your EuControl software to arrange the layout of multiple units. For more information, see
EUCON Application Setup.pdf.