User guide

Artist Transport User Guide8
7 Plug one end of the Ethernet crossover cable into the Ethernet jack on the back panel of the Artist Transport.
8 Plug the other end of the Ethernet crossover cable into an open Ethernet jack on your computer, router, or Ethernet switch. Note
that connecting directly to the computer may require removing your Internet cable.
If you have a Mac with two Ethernet ports, it is recommended to use Ethernet 1 rather than Ethernet 2. However, if you want to use
Ethernet 2 do the following:
• Go to System Preferences > EUCON.
• Change the
Network Interface to Ethernet 2.
• Restart the computer.
An Ethernet router or switch is required to connect multiple Artist Series units such as an Artist Transport with one or more Artist
Mix controllers, or to connect units to a local area network.
9 Turn on your router (if applicable), then turn on your computer and wait until it finishes starting up.
Ethernet cable and rear panel jack
Artist Transport connected directly to a computer
Artist Mix and one Artist Transport connected to a computer through an Ethernet router (or switch)
SOLOSOLO ON ON SOLOSOLO ON ON SOLOSOLO ON ON SOLOSOLO ON ON