User guide

Artist Transport User Guide12
Operational Basics
The most important controls on Artist Transport are the Jog Wheel and Shuttle Ring. They typically jog and shuttle through a
session or project timeline but can also be assigned different functions.
In addition to the six dedicated, assignable Soft Keys, the Numeric Pad and Transport Controls serve as additional Soft Keys and
can also be reassigned.
All wheel, ring, and key assignments are stored in an Application Set for each application you use. Most applications have a default
Application Set to support common tasks. You can use these as a starting point to modify and store your own Application Sets. You
can restore the default Application Set at any time.
The top-most application (also called foreground and in-focus):
• Receives mouse commands and keystrokes
• Is controlled by Artist Transport
• Determines Artist Transport surface assignments
POWER
Press and release the POWER switch to turn the device on and off.
Reset
You can reset the surface name and (any) IP Address assigned to the unit by doing the following.
To reset the Artist Transport Surface Name and IP Address:
1 Make sure the unit is powered off.
2 Press and hold Soft Key 6 while pressing the POWER switch.
SHOW Key
Various functions can be assigned to Artist Transport keys. The SHOW key lets you browse the key assignments:
To use the SHOW key:
1 Press and hold the SHOW key.
2 Press another key.
The key’s function name is shown on the Artist Transport display and above the image of that key in EuControl.
Locking the SHOW Key
The SHOW key can be locked to let you browse multiple key functions without holding the SHOW key down.
SHOW key