Instruction manual

Chapter 2: Installation and Configuration 15
Configuring a SYNC Peripheral in
the Session Setup Window
When a SYNC peripheral is connected through
Loop Sync and enabled in the Peripherals dia-
log, its settings become available in the
SYNC Setup and Time Code Settings sections of
the Session Setup window.
Clock Source
When connected and configured in the Loop
Sync chain, the SYNC peripheral appears along
with any Pro Tools|HD interfaces in the Clock
Source pop-up menu, located in the Session
Setup window.
The Clock Source can be any device in the Loop
Sync chain. This lets you use any digital input
source available on any Pro Tools|HD interface
(including the SYNC peripheral) simply by se-
lecting that device and source from the
Clock Source pop-up menu.
Clock Reference
The selected Clock Source device determines
your choices for clock reference.
When Clock Source is a SYNC peripheral
When a SYNC peripheral is set to be the Clock
Source, it is the Loop Master. Clock, Positional
Reference, and Video Format selectors become
active in the SYNC Setup section of the Session
Setup window.
SYNC peripheral Clock Reference choices in-
clude:
• Internal/VSO
•Video In
•Video Reference (SD)
• Video Reference (HD) (SYNC HD Only)
•LTC
• Bi-Phase
• Pilot Tone
•AES/EBU
• Word Clock
• Loop Sync
Session Setup window
See the Pro Tools Reference Guide for more
information on the Session Setup Window.
SYNC peripheral selected as Clock Source in the
Session Setup window
Session
settings
SYNC
Setup
Time Code
Settings
Clock Source
Clock Source
SYNC Setup controls in the Session Setup window