Instruction manual

SYNC HD Guide60
Set Generator Start Time
Lets you set a start time for the SYNC peripheral
time code generator.
See “Generator Start Time” on page 51.
Digital Clock Reference
The SYNC peripheral can use AES/EBU or Word
Clock (1x) for digital clock reference.
See “Digital Clock (AES/EBU or Word Clock) Op-
tions” on page 38.
Sample Rate
Selects the SYNC peripheral sample rate.
See “Sample Rate” on page 17.
Pull Rate
Two Pull Rate settings enable 0.1%, and 4%, Pull
Up or Pull Down for the current sample rate.
Pull Rate1 Lets you enable 0.1% pull up or
down.
Pull Rate4 Lets you enable 4.167% pull up, or
4.0% pull down, when available.
SYNC peripheral front panel display of parameters
LED Parameter
SE7 6En Set Generator Start Time
dI6 rEF Digital Reference
SPL FrEC Sample Freq (Rate)
PuLL r7E 1 Pull Up/Down 0.1%
PuLL r7E4 Pull Up 4.167%, Down 4.0%
bASE CLOC External Clock Out
VI7C InS VITC Insertion
rdr LInE (VITC) Reader Line
6En LInE (VITC) Generate Line
burn EnA Window Burn On/Off
FrEE LEn Freewheel Duration
L7C LEUL/GAIn LTC Output level/gain
SErVo Gn LTC Servo gain
PICH HLd Pitch Hold On/Off
bIPH PPF Bi-Phase Pulse-per-frame
bIPH SI6 Bi-Phase Signal Configuration
VIdEO SY Video Format (NTSC/PAL)
Hd VIdEo HD Video Format (SYNC HD only)
IdLE 7C Idle MTC On/Off
dEvicE id Device ID (SYNC HD only)
USd CPA7 USD Compatibility mode On/Off
(SYNC I/O only)