Instruction manual

SYNC HD Guide64
Bi-Phase/Tach Pulses Per Frame
Bi-Phase/Tach involve several settings, includ-
ing pulse per frame. This sets the number of Bi-
Phase/Tach pulses per frame of time code.
To set the pulses per frame value for a
Bi-Phase/Tach signal:
1 Select Bi-Phase/Tach Pulses Per Frame
(“bIPH PPF”), using the Set, Down, and Up
switches.
2 Press Set.
3 Use the Down and Up switches to scroll pa-
rameter values.
4 Press Set. The SYNC peripheral retains the set-
ting, even when the unit is powered off and on
again, until it is changed.
Bi-Phase/Tach Input Signal
In addition to other Bi-Phase/Tach parameters,
the Input Signal defines the direction of the Bi-
Phase/Tach signal.
For complete instructions, see “Bi-Phase/Tach
Signal” on page 47.
Video Format/System
Selects the format (NTSC or PAL) for both the in-
coming and outgoing video signals.
NTSC The standard for North and South Amer-
ica, Japan, and certain other parts of the world
PAL Used in most of Europe, Asia, and Africa.
Users of SECAM video (for France, Russia, and
other parts of the world) should select PAL.
To select a video system:
1 Select Video System (“VIdEo SY”), using the
Set, Down, and Up switches.
2 Press Set.
3 Use the Down and Up switches to toggle the
parameters between the following:
• NTSC (“n75C”)
• PAL (“PAL”)
4 Press Set. The SYNC peripheral will retain the
setting, even when the unit is powered off and
on again, until it is changed.
Be sure you have selected the correct video
format. The SYNC peripheral will not warn
you if you have chosen the wrong one.