Instruction manual

SYNC HD Guide68
Restoring Factory Settings
A SYNC peripheral can be reset to its default fac-
tory settings.
To reset all parameters to default settings:
1 Switch off power to the SYNC peripheral and
wait at least 10 seconds.
2 Hold both the Up and Down front panel
switches and turn on power to the SYNC periph-
eral. Do not release the Up and Down switches
until the display reads “FAC-CFG.”
Factory Default Settings
The following table lists the default settings of
each parameter.
Resetting factory settings does not reset the
SYNC peripheral oscillator. See “Calibrat-
ing the SYNC Peripheral Oscillator” on
page 66 for information.
SYNC Peripheral Defaults
Parameter Name Default
Set Generator Start Time
01:00:00:00
Digital Reference
AES/EBU
Sample Freq (Rate)
44.1 kHz
VITC Insertion
On
Pull Rates
Off
Base Clock
Session (1x Word)
(VITC) Reader Line
All
(VITC) Generate Line
14–16
Window Burn On/Off
On (Enabled)
Freewheel Duration
8 frames
LTC Output level
+3 dBu
Servo gain
0000
Pitch Hold
Off
Bi-Phase Pulse-per-frame
0100
Bi-Phase Signal
A Lead B
Video System/Format
NTSC
Idle MTC Enabled
On
Window Burn options:
Enabled
Size: Large
Vertical Position: 20% from
Bottom
Horizontal Position: Center
Color: White on Black
background
Variable Speed Offset
(VSO)
Off