Setup guide

Connecting the Windows Ethernet Client
19
c
When you are connecting the Ethernet client to the Ethernet switch,
use only Category 5 or Category 5e Ethernet cables. Using other
cables can cause client performance problems.
To connect the client’s Ethernet port to the Ethernet switch:
1. Connect one end of the Ethernet cable to the Ethernet port on the rear
of the client (see Figure 3).
Figure 3 Connecting the Ethernet Cable to the Ethernet Client
2. Connect the other end of the Ethernet cable to an empty
10BASE-T/100BASE-T port, from port 1 through port 15 on the
Ethernet switch (see Figure 4).
Figure 4 Ethernet Switch Ports
Ethernet cable
Ethernet port
Ethernet connector
To Ethernet switch
Ports 1 to 8
Ports 9 to 15