Setup guide

Chapter 1 Installing the MediaNetwork Windows Fibre Channel Client Hardware
20
FailOver File Manager if you have one. You should connect storage starting at
Port 15 and go to Port 10, for a maximum of 6. All remaining ports can be
used to connect MediaNetwork clients.
n
Any ports, 15 through 10, not used for storage can be used as client ports.
MEDIASwitch 16-4G Port Configuration
Connecting to a 4-Gb MEDIASwitch 16-4G
To connect an optical cable to the 4-Gb MEDIASwitch 16-4G:
1. Locate the SFP in the Windows client kit.
2. Route the cable from the Windows client to the MEDIASwitch 16-4G, if
it has not been installed already.
3. Position the SFP in front of a MEDIASwitch 16-4G port (see the
following figure). Make sure the optical connector is facing away from the
MEDIASwitch 16-4G.
n
You can install the SFP while the MEDIASwitch 16-4G is turned on.
a
File Manager port
MediaNetwork client ports
Storage ports
Port 15
Port 0