Setup guide

Connecting a Fibre Channel Client to a Network
31
Using the Built-in Network Port
To connect a Fibre Channel client with a built-in Ethernet port to the site
network:
1. Connect one end of the Ethernet cable to the Ethernet port on the rear of
the client (see “Connecting a Client to a Network Using the Ethernet Port”
on page 31).
2. Connect the other end of the Ethernet cable to a site network jack.
Using an Ethernet Peripheral Board
To connect a Fibre Channel client with an optional 10/100BASE-T
Ethernet peripheral board to the site network:
1. Install the Ethernet peripheral board as described in the manufacturer’s
documentation.
2. Connect the Ethernet cable to the Ethernet port on the Ethernet board (see
“Connecting a Client to a Network Using the Ethernet Port” on page 31).
3. Connect the other end of the Ethernet cable to a site network jack.
Connecting a Client to a Network Using the Ethernet Port
Ethernet port (on
Windows workstation
or on optional
Ethernet board)
To site network jack
RJ-45 connector
Ethernet cable