User Manual
Table Of Contents
- Contents
- Welcome to Mbox
- Installing Pro Tools on Mac
- Installing Pro Tools on Windows
- Configuring Your Pro Tools System
- Mbox Hardware Overview
- Making Hardware Connections
- Using the Driver Control Panel
- Using the Multi Button
- Configuring AMS (Mac OS X Only)
- Configuring MIDI Studio Setup (Windows Only)
- Hard Drive Configuration and Maintenance
- Troubleshooting
- Resources
- Compliance Information
- Index
Chapter 5: Mbox Hardware Overview 31
chapter 5
Mbox Hardware Overview
Mbox Front Panel Features
Figure 1 identifies controls, indicators, and input and output ports on the front panel on the Mbox.
The Mbox front panel provides the following:
Signal/Clip LEDs
These LEDs illuminate green in the presence of
audio signal, and illuminate red if the signal
reaching Mbox has clipped.
Gain Controls/-20dB Pad
These knobs adjust the input gain levels of the
Mic/Line inputs. Turn the knob clockwise to in-
crease gain, and counter-clockwise to decrease
gain.
If your input signal is too hot even with the
Gain knob at a low setting, pull the Gain knob
out to engage a “pad” that attenuates the signal
by 20dB.
Instrument Inputs
These 1/4-inch TS inputs are for connecting an
electric guitar, bass, or other instrument-level
signal. The level for these inputs is controlled by
the Gain Controls.
Figure 1. Mbox front panel
48V
USB
Headphone
Headphone
Source
selector
LED
Input 1
Volume
Output
Monitor
Level
Dim
Gain/
Source
selector
Input 2
Sig/Clip
LED
Mono
Soft Limit
Soft Limit
Instrument
Instrument
Multi
-20dB
Sig/Clip
LED
Gain/
-20dB