User Manual

HD I/O Guide28
3 Remove all of the small Phillips-head screws
around the edges of the top cover. Put the screws
in a safe place.
4 Lift off the top panel of the HD I/O and set it
aside.
5 Remove the screws on the back panel for the
I/O card you want to remove.
6 Holding the 50-pin cable which connects the
card to the HD I/O chassis firmly, gently pull the
cable connector from the card’s connector.
7 Gently remove the card, pulling it straight out
from the chassis.
Removing the top cover screws
Removing the screws securing an I/O card
Removing the 50-pin cable connector from an I/O card
Removing an I/O card from the HD I/O chassis
When you pull a card out, pay particular
attention to keeping components on the
surfaces of the card from bumping into any
of the internal components or the back panel
faceplate on the HD I/O.