User Manual

Installation and Setup 6
Installation and Setup
This chapter shows how to get your S1 set up as a studio controller, and consists of the following steps:
Unpacking S1
1 Open the S1 box and find the white Welcome/Start Here envelope.
• You will use the included Activation card to activate your S1 and download EuControl software later in the installation pro-
cedure.
2 Remove the cardboard tray holding your S1 accessories (Ethernet cable, Link plate (for joining two S1s together), power
adapter, and power cables).
• Identify the IEC power cable appropriate for your location.
• Set the IEC cable, Ethernet cable, power adapter, and Link plate aside.
3 Carefully remove the S1 its packaging.
• Remove the protective tape across the fader strips (this tape holds the faders in place during transportation, but must be re-
moved).
• Remove the protective film from the displays across the top of the fader strips.
•
Unpacking S1
• Connecting S1
• Installing EuControl Software
• Enabling EUCON in Pro Tools
• Confirming EUCON
Removing protective film from the displays