User Manual
S1 Surface Controls Overview 27
Basic Channel Encoder Use
When S1 is first powered on, the Channel Encoders are in Normal Mode and Pan is assigned to the Channel Encoders by default.
Each Channel Encoder controls pan for its corresponding track on the strip.
To quickly access pan control on the Channel Encoders in Normal Mode:
Press the Pan Channel Encoder Assignment switch.
To enable Channel Mode (see the figure below):
1 Press a Channel Sel switch to attention that track.
2 Press Surface SHIFT + Flip/Chan.
3 Press the channel Encoder Assignment switch for the desired function such as Inserts or EQ.
The encoder displays show parameters for the selected function.
4 To exit Channel Mode, press Shift + Flip again.
Remember, for functions listed above each switch such as Input, Inst, HEAT, Group, or Mix, hold Surface SHIFT while pressing
its switch.
Enabling Channel Mode: Select a track (1), press Surface SHIFT + Flip/Chan (2), then select a function (3)
Pressing the EQ Channel Encoder Assign Switch automatically enables Channel Mode as well.
1
3
2 2