User Manual-MADI

Chapter 4: Configuring HD OMNI in Pro Tools 23
chapter 4
Configuring HD OMNI in Pro Tools
Pro Tools Hardware Setup
The Pro Tools Hardware Setup dialog lets you
configure HD OMNI for use with Pro Tools. It
also lets you configure some of the same settings
as in Setup mode on HD OMNI (see Chapter 5,
“SETUP Mode”). In addition to the standard
Main, Analog In, and Analog Out tabs, the Hard-
ware Setup dialog provides the Monitor and
Mixer tabs that are unique to HD OMNI. Note
that all HD OMNI specific hardware settings (ex-
cept labels) are stored in HD OMNI itself.
To configure HD OMNI in Pro Tools:
1 Choose Setup > Hardware.
2 From the Peripherals list, select the HD OMNI
audio interface.
3 Click the Monitor tab and configure the op-
tions (see “Monitor” on page 26).
4 Click the Main tab and configure the options
(see “Main” on page 23).
5 Click the Analog In tab and configure the op-
tions (see “Analog In” on page 25).
6 Click the Analog Out tab and configure the op-
tions (see “Analog Out” on page 26).
7 Click the Mixer tab and configure the options
(see “Mixer” on page 34).
8 Continue by configuring any other HD audio
interfaces connected to your system.
9 When you are finished, click OK.
Main
The Main page of the Hardware Setup dialog is
where you define which physical inputs and
outputs on your audio interface are routed to
available inputs and outputs in Pro Tools. You
can think of this window as a patchbay that lets
you route any of the inputs or outputs on your
Pro Tools|HD audio interfaces to channel as-
signments in the Pro Tools mixer.
Because the Monitor configuration affects
the available Output paths, be sure to con-
figure the Monitor page before configuring
the other pages in the Hardware Setup and
the I/O Setup.
Hardware Setup, Main page