User Manual

Preparing to Capture Audio
207
In Direct Mix mode, the Pan Value display and pop-up sliders at the bottom of the
Passthrough Mix tool are replaced by Channel Menu buttons.
3. Select the audio channel to be adjusted by doing one of the following:
t Click the Channel Selection button for the appropriate audio channel.
t In Direct Out mode, click the Channel Menu button, and select a channel from the
menu.
You can select only channels that exist in the source audio.
4. Adjust the volume as needed.
You can adjust the volume of multiple channels by clicking the appropriate Group button.
For more information, see the next procedure.
5. Adjust the pan values as needed.
For more information, see the final procedure in this topic.
To change an audio level value in the audio panel in the Passthrough Mix tool, do one of
the following:
t Click a number along the vertical edge of the Volume Level slider.
t Click the Volume Level slider, and type a value.
Values are cumulative until you press Enter (Windows) or Return (Macintosh). For example,
if you want to enter the value 12, type it. However, if you type 1 and then want to change the
value to 2, press Enter (Windows) or Return (Macintosh) before typing
the 2.
t Click the Volume Level slider, and drag the slider to a new position.
t Click the Volume Level display, and type a value.
t Alt+click the Volume Level slider to reset the value to 0 dB.
To adjust the pan values in the audio panel of the Passthrough Mix tool:
t Click the Pan Value display to reveal the pop-up slider, and then drag the slider to a new
position.
Pan Value display (left) and pop-up slider (right) in the Passthrough Mix tool.