User Manual

Core Avid Audio Plug-Ins
966
BF Essential Clip Remover (AudioSuite)
The BF Essential Clip Remover repairs clipped audio recordings. If you have an audio clip
where acceptable levels are exceeded in at some points, try applying this plug-in. In many cases,
it can save you from having to re-record the audio.
Envelope Provides an envelope follower for controlling the Cutoff frequency, which allows you to control
the envelope’s shape and depth of modulation.
• Attack — Sets the time (10.0 ms to 10 seconds) it takes to respond to increases in the audio
signal level.
• Release — Sets the time (10.0 ms to 10 seconds) it takes to recover after the signal level
falls.
• Depth — Determines how much the envelope follower affects the Cutoff frequency.
- At 0%, the envelope follower has no effect on the Cutoff frequency.
- At +100%, the Attack ramps up to the Cutoff frequency setting, and the Release starts
from the Cutoff frequency setting and ramps down.
- At –100%, the Attack starts from the Cutoff frequency setting and ramps down, and
the Release ramps up to the Cutoff frequency setting.
LFO Provides a sinusoidal Low Frequency Oscillator (LFO) for modulating the filter cutoff
frequency, which allows you to control the rate, depth and synchronization of the modulation.
• Sync — Turns on and off the synchronization between the LFO and the sequence tempo.
• Rate — Increases or decreases the frequency (0.01–100.0 Hz) of the LFO. Lower settings
are slower and higher settings are faster. When you enable Sync, the Rate knob changes from
counting in milliseconds to rhythmic values.
• Depth — Increases or decreases the amount of modulation (0–100%) of the Cutoff
frequency by the LFO. Lower settings create a slight vibrato (with the rate set high) and
higher settings create a wide sweep of the Cutoff frequency range.
Mode Select one of the following options for the type of filter:
• LP24 — Provides a low pass filter with a 24 dB cutoff.
• LP18 — Provides a low pass filter with a 18 dB cutoff.
• LP12 — Provides a low pass filter with a 12 dB cutoff.
• BP — Provides a band pass filter.
• HP — Provides a high pass filter.
Output Lets you lower the Output level from 0.0 dB to –INF dB.
Parameter Description