User Manual

Preparing for Audio Output
1054
2. Click the PH (Peak Hold) menu, and select Set Calibration Tone.
The Set Calibration Tone dialog box opens.
3. Type new values for the tone level and frequency text boxes, and click OK.
To play back the tone:
t Click the PH (Peak Hold) menu, and select Play Calibration Tone.
To check the adjusted tone level in the meters:
t Switch the In/Out toggle buttons to O for Output.
Calibrating Global Output Levels
You can use the meters in the Audio tool to monitor the global output level of your sequence. If
necessary, you can use the Output Gain slider (master attenuator) in the Output tab in the Audio
Project Settings dialog box to adjust the output from the system. These adjustments affect levels
for all output tracks to both the speakers and record devices.
c
You should leave this output level at the factory preset of 0 dB. Adjust the level only when
necessary to raise or lower the overall volume, based on the headroom parameters of the
record format, or for consistently overmodulated or undermodulated source material.
To calibrate global output levels:
1. Double-click Audio Project in the Settings list in the Project window.
The Audio Project Settings dialog box opens.
2. Click the Output tab.