User Manual

Using the Digital Cut Tool
1064
In Remote mode, the Digital Cut tool includes its own deck controls for:
• Cueing a record deck from the Digital Cut tool.
• Cueing the tape and adding an IN point. This capability applies when you click the menu in
the deck control area, and select Mark In Time.
The Mark OUT button does not appear in the deck controller section of the Digital Cut tool
because it has no effect on digital cuts. Also, the Mark OUT and Duration text fields are
read-only. You cannot alter them.
n
Depending on the system configuration, you might need to use the deck controls in the Capture
tool to review a digital cut.
The controls and options that appear in the Digital Cut tool depend on the device and format you
select. The following illustrations show two examples. This illustration shows the Digital Cut
tool configured for DV output to a device connected to the 1394 port.
134526
7
8
9
10
1 Sequence Track buttons 6 Ref Lock icon
2 Enable Track buttons 7 Deck controls