User Manual

Using the Dynamic Relink Settings Dialog Box
1268
2. Select Enable Dynamic Relink.
3. Click the Working Settings tab, and then select your working settings.
For information on available settings, see “Dynamic Relink Settings” on page 1376.
4. Click the Target Settings tab, and then select your target settings.
For information on available settings, see “Dynamic Relink Settings” on page 1376.
5. To apply the settings, do one of the following:
t Click Apply.
The dialog box remains open.
t Click OK.
The dialog box closes.
As long as Dynamic Relink is enabled, your Avid editing application uses the working
settings to dynamically relink material while you edit. Applying the target settings, however,
does not dynamically relink a sequence to the target settings. You need to take one of the
actions described in “Dynamically Relinking to the Target Settings” on page 1271”.
n
You can use the MultiRez button in the Timeline to instruct your Avid editing application to color
any clips for which media is not available. This is especially important because it indicates if you
can create the finished sequence in the target resolution. For more information, see “Displaying
Whether Media Is Available for Dynamic Relinking” on page 1274.
Examples of Working and Target Settings for Dynamic Relink
This topic provides examples of typical working and target settings for Dynamic Relink. For
information on applying settings, see “Applying Working and Target Settings for Dynamic
Relink” on page 1267.
Working Settings
The working settings in the following illustration instruct your Avid editing application to link to
the specific video resolution of 15:1s MXF. If it cannot find this resolution for a particular clip, it
should display a “Media Offline” slide. Specific parameters are also set for audio: 44.1 kHz and
16-bit.