User Manual

Video Output Tool Settings
1447
Video Output Tool Settings: SD Cal Tab
Settings menu Lets you save the settings for an individual tape each time you calibrate bars.
Option (Continued) Description
Option Description
Output menu Lets you select either Component, Composite, S Video.
On some systems, all outputs on the input/output hardware are active.
Select an analog signal from the Output menu to calibrate for output. For
more information, see “Calibrating for Video Output” on page 1043.
H Phase Lets you adjust the horizontal blanking interval used to synchronize the
timing of two or more video signals. Available on some systems for the S
Video, Component, or Composite output.
Hue Lets you adjust an attribution of color perception based on varying
proportions of red, green, and blue in the video signal (also known as color
phase). Available for S Video or Composite output.
Sat Lets you adjust saturation, a measurement of chrominance or the intensity
of color in the video signal. Available for S Video or Composite output.
SC Phase Lets you adjust the subcarrier phase (the color-burst portion of a signal used
to synchronize the timing of two or more video signals). Available for S
Video or Composite output.
Setup Lets you set the relative lightness and darkness of images. Available for S
Video, Component, or Composite output.
Gain Lets you adjust the variation of the lightest or brightest in comparison to the
darkest portions of the image. Available for S Video or Composite output.