User Manual

Setting Up the Capture Tool
193
Pulldown button in the Capture tool
When the pulldown switch is on a label explains that you can capture audio sampled at 0.99
percent of its recorded speed (referenced to NTSC video), to match the slowdown rate at
which the footage was transferred.
Film Project Pulldown and Transfer Settings
The following table explains how you should set the pulldown switch and transfer settings,
depending on your input media.
Type of Input Media Project
Pulldown
Switch
Setting
Source
Playback
Speed
Film to Video Transfer
Settings (Set in Film
Settings Dialog Box)
Original sound source synced to NTSC
during transfer. For capturing picture
and sound from NTSC tape, or
sound-only from simul-DAT tapes
created during telecine transfer.
24p NTSC On (0.99) 29.97 fps Picture Transfer Rate:
With 2:3 pulldown
NTSC MOS film-to-tape transfer with
separate audio. Digital audio (DAT) or
analog audio (Nagra) to sync with video
in your Avid system. For direct input of
separately recorded audio.
24p NTSC Off (1.00) Audio:
30.00 fps
Picture:
29.97 fps
Picture Transfer Rate:
With 2:3 pulldown
Audio Source Tape TC
Rate: 30.00
FTFT transfer or retransferring an
effect. This method lets you save time
because no audio is involved in the
transfer.
24p NTSC Not
applicable
29.97 fps Picture Transfer Rate:
Without pulldown