User Manual

Using Clip Volume and Pan Mode
799
The keyboard can control either the Source or Record monitor, depending on which monitor
was active when you opened the Audio Mixer tool. Switch your selection by clicking the
appropriate monitor.
7. Decide whether to raise or lower the volume.To change an audio level value in a mix pane,
do one of the following:
t Click a number along the vertical edge of the Level slider.
t Click the Level slider, type a value, and press Enter (Windows) or Return (Macintosh).
Values are cumulative until you press Enter (Windows) or Return (Macintosh). For example,
if you want to enter the value 12, type it. However, if you enter 1 and then want to change the
value to 2, press Enter (Windows) or Return (Macintosh) before typing the 2.
- Click the Volume Level display, type a value, and press Enter (Windows) or Return
(Macintosh).
- Click the Level slider, and then drag the slider to a new position.
- Alt+click (Windows) or Option+click (Macintosh) the Level slider to reset the value to 0
dB.
Top to bottom: Group, Stereo Link, and Stereo Mirror buttons; Pan controls and pan display; Audio Level
sliders and meters; and Volume Level display in the Audio Mixer tool
8. Decide if you want to adjust pan values. To adjust the pan values in a mix pane, do one of the
following:
t Click the Pan control, and then drag the control to a new position. Drag left or up to pan
to the left, or drag right or down to pan to the right.