User Manual

Configuring EuControl Settings
897
To set a static IP address (Avid Artist Mix):
1. Press and hold the Page Left and Page Right keys while you press and release the Power
button.
The Use DHCP screen appears in the channel display for fader strip 1.
2. Turn the knob underneath the display clockwise to change the Use DHCP value from yes
(default) to no.
You can use the SEL and ON keys instead of the knob to decrease or increase the value,
respectively.
3. Press the Page Right key or the Top key to move the cursor to the next screen.
4. Use the knob to set the value of the IP Address field.
5. Repeat step 3 and step 4 to adjust all values of the IP Address and the Subnet Mask fields.
You can press the Page Left key to move the cursor back to the previous field or screen to
change a parameter to a different value.
6. Press the Page Left and Page Right keys at the same time to save this static IP address. Turn
off the controller and then turn it on to use the new IP address.
You can discard changes made to the IP address at any time by turning off the controller
before saving your changes.
Configuring EuControl Settings
Before you can use an Artist Series controller with your Avid editing application, you must
configure the EuControl settings. You can connect your Artist Series controller to the EuControl
application on your system so you can use it as a controller, connect additional workstations so
they can access the controllers, and assign functions to buttons and keys on the Artist Series
controller.