User Manual

Core Avid Audio Plug-Ins
951
AIR Kill EQ (RTAS)
You can use the Kill EQ plug-in to remove the Low, Mid, or High broadband frequency range
from an audio signal. This is a popular effect with DJs and is commonly used in electronic music
production (especially in dance music).
The following table lists the AIR Kill EQ plug-in parameters:
AIR Lo Fi (RTAS)
You can use the Lo Fi effect to bit-crush, down-sample, clip, rectify, and mangle the input signal.
The following table lists the AIR Lo Fi plug-in parameters:
Mix (overall) Lets you balance the amount of fuzz-processed signal with the amount of wah-processed signal.
At 50%, there are equal amounts of fuzz and wah signal. At 0%, the output is all fuzz, and at
100% it is all wah.
Parameter Description
Parameter Description
High Switches the high frequency band on and off.
Mid Switches the middle frequency band on and off.
Low Switches the low frequency band on and off.
Gain • Low — Controls the volume of the low frequency band.
• Mid — Controls the volume of the middle frequency band.
• High — Controls the volume of the high frequency band.
Freq • Low — Sets the crossover frequency of the low pass filter.
• Sweep — Changes both the low and high-band cutoff frequencies simultaneously. When you
kill the high and low bands, manipulating this control creates a swept bandpass filter effect.
• High — Sets the crossover frequency of the high pass filter.
Output Sets the final output volume.
Parameter Description
Sample Rate Lets you resample the audio signal at another sample rate.