User Manual

Pro Tools Reference Guide1038
C|24
C|24 lets you adjust HEAT Master Controls from encoders 21–24, and HEAT channel controls in each
channel strip.
Master Controls
To access HEAT Master Controls on C|24:
 Press the Soft Keys switch in the Channel Bar. To exit, press the Soft Keys switch again.
HEAT Master Controls are mapped to the encoder and encoder switches of channel strips 21–24, as shown
in Table 1 on page 1038.
Channel HEAT Bypass and Pre/Post
When HEAT is enabled in a session, each channel strip provides HEAT Bypass and Pre/Post. You can ac-
cess these channel settings directly from C|24 channel strips. Channel HEAT controls follow Do To All
and Do to All Selected modifiers.
To access HEAT channel controls:
1 Make sure HEAT is enabled in the current session.
2 In the channel strip, press and hold the channel Insert switch. To exit, press the same switch again.
To toggle a channel in or out of HEAT Bypass:
 Press the channel Bypass switch.
To toggle a channel between (HEAT) Pre or Post Inserts:
Rotate the channel encoder, or press the encoder switch, and choose Pre or Post.
Table 1. HEAT Master Controls on C|24
Encoder: 21 22 23 24
Parameter
HEAT (On/Off) MstByp (Master
Bypass)
Drive Tone
Action
Press the Encoder
switch to toggle
Press the Encoder
switch to toggle
Rotate encoder Rotate
encoder