User Manual

Pro Tools Reference Guide80
Resetting Busses
You can reset the number of available internal mix
busses in your session to match your system’s full
capabilities by reverting to the default bus config-
uration.
To revert to the default bus configuration for your
system:
1 Open the I/O Setup.
2 Click the Bus tab in the upper left.
3 From the pop-up menu to the right of the Default
button, select one of the following:
•
All Busses
•
Output Busses
•
Internal Busses
4 Click Default.
5 Click OK to save changes and close the I/O
Setup.
Active Busses
The Bus page of the I/O Setup displays the number
of active internal mix busses. If the number of ac-
tive busses exceeds the number of available bus-
ses, the display turns red. Delete or deactivate any
active busses in excess of the available number of
busses to be able close the I/O Setup and save your
settings.
Sorting Bus Paths
The Bus page provide controls to sort busses by
name (ascending or descending), format (ascend-
ing or descending), or by mapped to output status
(ascending only).
To sort bus paths by Name:
1 In the Bus page, click the Name column header.
2 Click the Name column header again to toggle
between ascending and descending sort order.
To sort bus paths by Format:
1 In the Bus page, click the Format column
header.
2 Click the Format column header again to toggle
between ascending and descending sort order.
To sort bus paths by Mapping To Output status:
 In the Bus page, click the Mapping To Output
column header.
Pro Tools creates 24 internal busses by de-
fault.
Resetting busses to the default setting will re-
name all busses to their default name (Bus
1–2, Bus 3–4, and so on).
Sorting bus paths in the I/O Setup
Click to sort by Name
Click to sort by map-
ping to output status
Click to sort by Format