User Manual

Chapter 6: I/O Setup 79
To assign the same channel to all selected mono
busses mapped to a multichannel output path:
1 Do one of the following:
• Shift-click to select contiguous mono
busses in the Name column.
• Command-click (Mac) or Control-click (Win-
dows) to select noncontiguous mono busses in
the Name column.
2 Option-Shift-click (Mac) or Alt-Shift-click
(Windows) a mono bus indicator and select the
channel from the pop-up menu.
To assign ascending (cascading) channels to all
mono busses mapped to a multichannel output:
 Command-Option-click (Mac) or Control-Alt-
click (Windows) the mono bus indicator of the
top-most mono bus and select the first channel
from the pop-up menu.
To assign ascending (cascading) channels to all
selected mono busses mapped to a multichannel
output:
1 Do one of the following:
• Shift-click to select contiguous mono
busses in the Name column.
• Command-click (Mac) or Control-click (Win-
dows) to select noncontiguous mono busses in
the Name column.
2 Command-Option-Shift-click (Mac) or Con-
trol-Alt-Shift-click (Windows) the mono bus in-
dicator of the top-most mono bus and select the
first channel from the pop-up menu.
Using Keyboard Modifiers When
Enabling or Assigning Output
Busses
Pro Tools lets you use keyboard modifiers when
enabling or assigning Output busses. These key-
board modifiers behave in the same way as when
assigning track inputs, and track and send outputs.
Being able to assign a single output bus to multiple
physical outputs is useful in cases where you want
to route a single source signal to two or more out-
puts. Rather than assigning multiple outputs on a
track-by-track basis, you can do it once in the
I/O Setup.
In the I/O Setup, the following keyboard modifiers
apply:
• Option-click (Mac) or Alt-click (Windows) to
apply to all busses.
• Command-Option-Shift-click (Mac) or Control-
Alt-Shift-click (Windows) to apply only to se-
lected Output busses.
• Control-click (Mac) or Start-click (Windows)
for each additional Output path you want to as-
sign an Output bus to.
• Command-Option-click (Mac) or Control-Alt-
click (Windows) to assign a bus to the selected
Output path and all subsequent busses to the
next available Output path sequentially.