Installation manual

AUX Pages 4-29
Datablock Item Title
and Image
Content
option if the IFD is not configured to
communicate with an external fuel flow
system.
*** Blank ***
Single blank line. (1 line)
NOTE
Forward Looking Terrain Alerting (FLTA) Inhibit
Overwrites Top Strip Selection
If any of “FLTA Inhibited”, “FLTA Off”, and “FLTA
Not Avail” states are active, they will overwrite any
datablock selection on the left side of the top strip.
Items that are factory defaults are identified in the table above
with an asterisk. If no fuel flow system is connected to the IFD,
the two fuel related factory default elements are replaced by the
double asterisked items. To restore factory defaults to the
datablock selections, press the bottom right IFD knob while on
the Datablock Setup page and then accept the green Confirm
dialog box that gets displayed or use the Presets selection in the
“Datablock” LSK.
TIPS AND TECHNIQUES
Selecting Desired Datablocks
If a desired datablock selection is greyed out in the
selection box, that means there isn’t currently
enough room to put it in the desired location. One
technique is to delete datablocks below the desired
location in order to make room. Each new
datablock selection will push older ones below it
“down the stack”.