Installation guide

English

Cable Connections

Connecting Power

NOTE: Do not perform this procedure if Power over Ethernet (POE) is

used.

If PoE is not available, the encoder needs to be powered through the

removable power connector block. Refer to the diagrams in this guide

for the location of the power connector block.

The device can be powered from 12 VDC or 24 VAC. The power

consumption information is listed in the product specifications.

To connect power to the power connector block, complete the

following steps:

1. Remove the power connector block from the device.

2. Remove the insulation from ¼” (6 mm) of the power wires.

Do not nick or damage the wires.

3. Insert the two power wires into the two terminals on the

power connector block. The connection can be made with

either polarity.

Use a small slotted (5/64” or 2 mm blade width)

screwdriver to loosen and tighten the terminals.

4. Attach the power connector block back into the receptacle

on the device.

Warning — This product is intended to be supplied by a UL

Listed Power Unit marked “Class 2” or “LPS” or “Limited

Power Source” with output rated 12 VDC or 24 VAC, 8 W

min. or PoE rated 48 VDC, 8 W min.