Installation guide

English

Setting the IP Address

Through the ARP/Ping Method

Complete the following steps to configure the encoder to use a

specific IP address:

1. Locate and copy down the MAC Address (MAC) listed on

the Serial Number Tag for reference.

2. Open Command Prompt.

From the Windows Start menu, select Run... then enter

cmd in the Run dialog box and click OK.

3. In Command Prompt, enter the following commands:

a. arp -s <New Encoder IP Address>

For example: arp -s 192.168.1.10 00-18-

85-12-45-78

b. ping -l 123 -t <New Encoder IP

Address>

For example: ping -l 123 -t 192.168.1.10

4. Reboot the encoder.

5. Close Command Prompt when you see the following

message:

Reply IP from <New Encoder IP Address>: ...