User`s manual

E-13
A Check of the Supplied Items and the Names of the Parts
Names and Functions of the Parts (Operation Panel)
1.ON/STANDBYLED
Lit red during standby and lit green when the projection
lamp is on. See Page E-23.
2.LAMP/COVERLED
Lit green during projection. Lit red when the air filter or
lamp unit cover is not in place.
• Atthetimeoftheprojectionlamplightingoperation,the
LEDashesforabout6secondsandthenlightsgreen.
• Atthetimeofaprojectionlamplightingfailure,theLED
ashesgreen.(Theashingintervalwhentheprojection
lampisoffwillbelongerthanwhentheLEDashesat
othertimes.)
• Whentheprojectionlampisoff,theLEDashesgreen
for 60 seconds and then goes off.
• Whenthe projection lamphasbeen used in excessof
1,900 hours, the LED ashes red; when use exceeds
2,000 hours the LED is lit a steady red.
See Page E-44.
3.TEMPLED
When the internal temperature has risen excessively, the
LED ashes redfor 10 seconds, then is lit a steady red.
See Page E-44.
LED List
LED State
Significance
ON/
STANDBY
LAMP/
COVER
TEMP
Off Off Off AC power OFF
Normal
condition
Red Off Off Standby
Green
Flashing
green
Off
Standby to start of projec-
tion
End of projection to
standby
Green Green Off Projecting
Red Red Off
Lamp cover open
Power
has been
switched
OFF
because of
the alarm
Lamp burned out
Lamp usage exceeds
2,000 hours
Red Orange Off Internal problem
Red Off Red
Temperature fault
Fan fault
Green
Flashing
red
Off
Lamp usage exceeds
1,900 hours
Alarm
sounding
Green Green
Flashing
red
Abnormal temperature
warning
4. ON/STANDBYButton
 Switches the power of the projector on or off (standby
mode).
• Onlythisbuttoniseffectivewhentheprojectionlampisoff.
See Page E-23.
5. INPUTButton
Press this to switch the input.
 The input switches as follows: OHP → PC → VIDEO or
OHP →VIDEO(D4)→ VIDEO.
See page E-25.
6. PORTRAITButton
 When OHP is selected: Changes the orientation of the
projectionimageto0°andto90°.Screensthathavebeen
switched over are displayed to match the width.
7.FREEZEOFFButton
Cancels the still image mode.
Cancels the still image mode.
This is used when checking the projection screen while
moving the document.
See Page E-29.
8. FREEZE/CAPTUREButton
Makes the projection screen image into a still image.
 When OHP is selected: Information will be saved to the
USB memory when the USB memory stick is inserted.
* When the USB memory stick is not inserted, the image
cannot be stored because only still images are dis-
played.
* Only for iP-01UE.
See Page E-28.
ON/STANDBY
LAMP/COVER
TEMP
FREEZE OFF
FREEZE/CAPTURE
PORTRAIT
INPUT
1 2
3 4 5 6 7 8