User`s manual

E-4
Safety Precautions
• Donotblockthelensfront
• Donotblockthelensfrontduringoperation.
The powerful rays passing through the lens may cause re or burns if you put anything in front of the lens or block the
lens with your hand during operation.
Warning
Please check the rating of the power cable.
Prior to using a power cable, please make sure that the cable is fully compliant with the power ratings and the type of the plug in
the area and, if not, purchase proper power cable for the area. Do not use the cables for 120V rating to 220V power source.
Using improper cable may cause re or electrical shock to human body.
CAUTION
• Installation
• Avoidinstallingtheprojectorinplaceswhereitmaybeexposedto:
- On tables, etc., that are vulnerable to heat.
- Strong vibrations
- Soot or steam
- Directsunlightornearaheater(35°C/95°Forhigher)
- High humidity or dust
- Extremecold(0°C/32°Forlower)
- Strong magnetic or electric eld generated from a nearby appliance
- Wobbling on an unstable surface
• Dependingontheinstallationenvironment(e.g.,besideawallorwhenaffectedbyairconditioningaircurrents),thehot
air expelled from the front may cause heat haze and the projection image may waver.
• Donotblocktheairvents.
• Donotblocktheairventswithclothoranobject.
When you put anything around the unit, be sure to ensure a space of 10 cm/4 inches or more between the unit and
the air vent. Be sure to prevent paper or cloth from blocking the air vent at the bottom of the unit. If blocked, the internal
temperature may increase, resulting in malfunctions.
• Donotbumptheprojector.
• Avoidbumpingtheprojectorwhenmovingorhandling.Shockscancausedamage.
• Careoftheprojector
• Topreventriskofaccidents,alwaysdisconnectthepowerplugbeforecleaningtheprojector.
• Cleanthelenssurfacewithacommercialblowerorlenscleaningpaper.
Wiping with tissue paper or a handkerchief can damage the lens.
• Tocleanthecabinet,operationpanel,andglasssurface,wipegentlywithasoftcloth.Forparticularlydirtyspots,soak
the cloth in a neutral detergent mixed in water, wring out well and wipe off the dirt, then use a dry cloth to wipe dry.
• Donotwipetheprojectorwithanyvolatilesolventsuchasbenzineorthinner.
The surface may change in quality, and the markings may peel off.
If using an impregnated cloth, follow the instructions of the cloth.
• Avoidscratchingtheglasssurface.
• Takecarenottoscratchtheglasssurfaceofthescannerwithhardorpointedobjects.
Scratches on the glass may distort the projected image.
• Battery
• Wheninsertingbatteryintheremote control,notethepolarity(plusandminussigns)andinsertcorrectlyasindicated.
Inserting a battery in a wrong direction can cause rupture or leakage, and could result in fire and injury or soil the
surrounding area.
• Donotusecoinbatteryotherthanthetypespeciedfortheequipment.Incorrectbatteryusagecouldresultinruptureor
leakage, and could cause re and injury.
• Donotheat,breakopen,burn,orimmersethebattery.Batteryruptureorleakagecouldcausereandinjury.
• PerchlorateMaterial-specialhandlingmayapply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate/index.cfm.