User`s manual

E-47

Maintenance

Removethelampunitcover

Using a minus screwdriver, loosen the screws of the

lamp unit cover, pull in the direction of the arrow, and re-

move the cover.

Loosenthemountingscrewsofthelampunit

Using a minus screwdriver, loosen the 2 screws of

the lamp unit.

Pulloutthelampunit

Hold the handle of the lamp unit and pull it up and out.

Installanewlampunit

❶ Take the lamp unit and press it into the projector.

❷ Check that the two positioning prongs on the bottom of the

lamp unit are securely t into the two holes.

❸ Tighten the 2 mounting screws of the lamp unit.

❹ Align the 2 tabs located on the lamp unit cover with the

projector and attach from the side of the tabs. Tighten the

mounting screws of the lamp unit cover.

Lamp Unit Replacement Procedure

Topreventburns,waitonehourorlongerafterthelamphas

been switched off before performing the following proce-

dure.

ツメ

Positioning protrusions