User`s manual

E-48
Maintenance
5
Resetthelampusagetime
Please perform the operation indicated below in the standbymode(*).
6
Checkthattheindicationofthelampus-
agetimehasbecome"0H"asillustrated
inthediagramtotheright.
If the usage time has not been reset, please reset it by
following Step 5 again.
Check the lamp usage time by pressing the menu button of
the remote control to display the menu, then use the scroll
◀▶ button to display the setup setting.
OperationwiththeProjector
PresstheINPUT,PORTRAIT,FREEZEOFFandFREEZE/CAPTUREbuttonssimul-
taneously, then press the input selector and still picture buttons simultaneously.
OperationwiththeRemoteControl
Resetting of the lamp usage time cannot be performed with the remote
control.
TheLAMP/COVERLEDwillashgreenfollowingthisandprojectionwillstart.
* The power plug is plugged into a power outlet and only the ON/STANDBY LED is lit red.
• Donotresetthelampusagetimewithoutreplacingthelamp.
The likelihood of the lamp rupturing becomes higher when the lamp has been used in excess of
2000 hours.
CAUTION
If the lamp is used without resetting the usage time, the correct lamp usage time will not be known;
therefore, be sure to reset the usage time after lamp replacement. When the indication exceeds 2000
hours, the projector will be forced to turn off the projection lamp.
CAUTION
NOTE:
• Intheinterestofsafety,thelampwillnotlightwhenthelampunitcoverisoff.
• Inregardtothedisposalofthelampunit,followthedisposalmethodofyourmunicipalityforthesametypeofwasteascom-
monhouseholduorescenttubes.