User`s manual

E-6
Safety Precautions
• Donotdothefollowings
• Donotputanythingheavyontheprojector.
• Donotstepontheprojector,rack,orstand.Donotholdorhangontheprojector.
Doing so could cause the projector to roll over or break, resulting in injury.
Especially be careful if small children are near.
• Donotusetherackunlessthecastersarelockedwhenplacingtheprojectoronarackwithcasters.
Doing so may cause the projector to move or roll over, resulting in injury.
• Donotturnthelampon/offwithinoneminuteafteritisturnedoff/on.Extremelyhighvoltageisgeneratedinthelampjust
after it is turned on. Turning the lamp on/off too frequently could cause the lamp to deteriorate or break, resulting in mal-
functions of the projector.
• Donotprojectanimagewiththelenscapattached.
• Donotusewiththeairlterremoved.Doingsocouldcausedamageormalfunction.
• Donotlifttheprojectorbygraspingthefocusadjustmentring.Doingsowillcauseafaultordamage.
• Afterdisconnectingthepowercablefromtheprojector,allowanintervalofatleast5secondsbeforeinsertingitagain.
• Movingtheprojector
Theunitismeanttobeusedinastationaryposition.
• Besurecarefuloftheglasssurfaceatmovingtheprojectorwhileholdingthehandles.
• Ifthedocumentcoverisnotinsertedenough,itmaygetlooseandfalloffwhileyoucarryit.
• Avoidswingingitaroundortreatingitroughly.
• Careofthepowercableandplug
• Donotputthepowercablenearaheater.
Doing so could cause the sheath of the cable to melt down, resulting in re or electric shock.
• Donotconnectordisconnectthepowercablewithwethands.Doingsocouldcauseelectricshock.
• Besuretoestablishagroundconnection.Thegroundconnectionmustbemadebeforepluggingthepowercableintothe
outlet.
Connect or insert the ground wire to a ground terminal only; do not connect it elsewhere.
• Besuretopulloutthepowercableanddisconnectanycableconnectionsbetweenunitsandreleasetheanti-theftlock
before moving the projector.
Moving the projector with cables connected may cause re or electric shock if the cables are damaged.
• DONOTREMOVEANYSCREWSexceptthelampcoverscrewandtwolampunitscrews.Otherwiseyoucouldreceive
anelectricshock.
• Abouttheprojectionlampandotheropticalparts
Opticalpartssuchasthelightsourcelamp,fan,andcolorwheelarepartsthatrequireperiodicreplacement(i.e.,periodic
replacementparts).
 Whentheprojectorisusedcontinuouslyforlongperiods(of5ormorehoursdaily),thereplacementofthosepartsmay
even become necessary in less than one year of use.
Note also that use of the projector in places where there is tobacco smoke or a lot of dust may shorten the replacement
cycle of the periodic replacement parts. Please inquire with the dealer for details.
• Keepyourfaceawayfromtheexhaustvents.
• If the lamp is broken, dust may enter your eyes or mouth. Be sure to keep your face away from the exhaust vents.
Otherwise, it may result injury.
 (Ifforeignmattersentertheeyes,consultanophthalmologist.)