Owner manual

DIP Switch Block 9 (SW9)
Switch Block SW9 controls network‑level functions and A‑Net transmit/receive settings.
DIP Switch Block 9 (SW9) Functions
Switch Function Off (down) Function On (up)
1 Auto Mode Manual Mode
2 A‑Net Transmit Port (A, B, or A+B) Select 0 * A‑Net Transmit Port (A, B, or A+B) Select 0
3 A‑Net Transmit Port (A, B, or A+B) Select 1 A‑Net Transmit Port (A, B, or A+B) Select 1
4 A‑Net Receive Port (A or B) Select * A‑Net Receive Port (A or B) Select
5 Transmit Audio Base Slot Select 0 * Transmit Audio Base Slot Select 0
6 Transmit Audio Base Slot Select 1 Transmit Audio Base Slot Select 1
7 Receive Audio Base Slot Select 0 * Receive Audio Base Slot Select 0
8 Receive Audio Base Slot Select 1 Receive Audio Base Slot Select 1
9
Card settings controlled by onboard DIP
switches
Card settings controlled by Pro64 Network
Manager software
10 Not Managed Managed Mode
* The tables that follow show DIP switch settings for transmit/receive.
Network Mode
The Pro64 network can be set to operate in either Auto Mode or Manual Mode using switch 1 in DIP Switch Block
SW9. The default setting is Auto Mode.
A-Net Transmit Settings (Manual Mode)
The 6416Y2 A‑Net Interface Card can transmit its activated channels to A‑Net Port A, B, or both A and B when the
network is running in Manual Mode. (This setting does not apply when the network is operating in Auto Mode.)
Use switches 2 and 3 to direct A‑Net data to a specific port.
A‑Net Transmit Settings
Port A
DIP Switch 2 DIP Switch 3
off off
Port B on off
Ports A and B off on
Not supported on on
P No t e : Manual Mode is not supported by Pro64 Network Manager or when AllFrame devices are part of the
network.
35
dIP sw I t c h fu n c t I o n s