Manual

25
Quick System Setup
For those who can’t wait to try their new product (or for those who hate reading manu-
als) follow these quick setup instructions to get up and running in no time.
Refer to the detailed setup and usage instructions later in this document for additional
information.
Start with all devices turned off. When all power and audio connections have been
made, you can then power up all the components in your system.
AC Power Connection
Both component parts of your Personal Monitor Mixing System use separate external
power supplies.
• Connect the power supply to the 18-24 VDC Power jack on the rear of the
A-16T Transmitter unit.
• Plug the power supply into an available AC power outlet.
• Connect the power supply to the A-16 Personal Mixer unit.
• Plug the power supply into an available AC power outlet.
The Personal Monitor System will be in its “on” state as long as it is plugged into a
working electrical outlet.
No on/off power switches are included on the A-16 System. If you would like to
control the power state of your units, simply connect the power supplies to a power
strip with an on/off switch. Use that as a system power switch.
System Interconnections
A single Category 5 cable is required to connect each A-Net compatible device in your
system.
Connect a Category 5 cable from the front panel A-Net jack on the A-16T Transmitter
to the A-Net In jack on the first Personal Mixer.
Connect additional A-16 Personal Mixers with a single Category 5 cable from the
A-Net Out jack on the first Mixer to the A-Net In jack on the next Personal Mixer.
(Repeat this process for each additional Mixer unit in your system.)