Manual

Aviom A-16 Personal Monitor Mixing System
28
29
Saving Your New Preset
It’s important to remember that your mix is not saved if you should power the system
down unless you store the mix as a Preset. You need to save a Preset to a memory
location to be able to recall it later. The Channel buttons serve as memory location
buttons when in Save mode.
To save a Preset:
• Hold down the RECALL and GROUP buttons, found in the upper left side of
the Mixer surface.
• While still holding the RECALL and GROUP buttons, press the Channel
button (1 through 16) corresponding to the memory location where you
want the mix to be stored.
• Release the Channel button to store a Preset; you will see all the Channel
LEDs flash in sequence as confirmation of the save operation.
• Release the RECALL and GROUP buttons after selecting a location.
If you want to store the same mix to multiple memory locations, you can press memory
location buttons as needed while the RECALL and GROUP buttons are being held down.
A copy of the mix will be saved to each memory location.
What Gets Saved
When you save a Preset the following information is saved:
• Channel volumes
• Channel pan settings
• The mute status of all Channels
• Channel Groups (up to three) and Group volume settings
• The current active Channel, linked pair, or Group
Tip: By selecting a Channel prior to saving a Preset you can always have your
favorite Channel ready for real-time editing when the Preset is recalled.