Instruction Manual

17re A r PA N e l Fe A t u r e s
In Auto Mode, both Pro64 A‑Net ports are identical. Cables from any Pro64
device can be plugged into either port. Multiple ASI A‑Net Systems Interfaces
can be used by connecting them to any available Pro64 A‑Net port, including
those found on MH10 Merger Hub ports.
Two Pro64 ports provide connections to other Pro64 devices.
In Manual Mode, the Pro64 data source is determined by the port settings on
the front panel of the ASI.
Pro16 Ports
Pro16 data is output though the four Pro16 ports on the ASI. The current
Pro64 network sample rate determines which Pro16 ports will be active. See
the section on Pro16 Output for additional information.
Pro64 data is output to Pro16 devices in blocks of sixteen channels.
 Note: The Pro16 ports on the ASI are outputs only. Do not connect the
A‑Net outputs from Pro16 input modules (including console cards)
to these ports. Pro16 data streams cannot be translated into Pro64
data using the ASI.