Instruction Manual

18Asi co N N e c t i o N s
ASI Connections
Building a Pro64 network involves connecting input and output modules,
setting A‑Net Slot ranges, and activating input channels. When added to a
Pro64 network, the ASI A‑Net Systems Interface will output Pro16 compatible
data from all active Pro64 channels. The maximum number of available Pro16
channels is determined by the current Pro64 sample rate.
The ASI can be connected to any available A‑Net port on a Pro64 I/O module
or merger hub such as the MH10.
Connecting Pro64 Modules
To create a network, set one (and only one) device to be the network Control
Master. Because there are some operations that can only be executed at the
Control Master, be sure that the module designated as the Control Master
is accessible. Once all modules in the network are enumerated (indicated
by illuminated A‑Net LEDs), choose a network mode (Auto/Manual), set
A‑Net Slot ranges on each module, and activate audio channels and VDCs
as needed.
Pro64 Series Connections
B A
B A
Input
B A
Output
B A
Input
B A
Output
B A
Input
B A
Input
B A
Output
1 2
Merger
3 4 5 6 7 8 9 10
B A
B A
Input
B A
Output
B A
Input
B A
Output
B A
Input
B A
Input
B A
Output
1 2
Merger
3 4 5 6 7 8 9 10
B A
B A
Input
B A
Output
B A
Input
B A
Output
B A
Input
B A
Input
B A
Output
1 2
Merger
3 4 5 6 7 8 9 10
B A
B A
Input
B A
Output
B A
Input
B A
Output
B A
Input
B A
Input
B A
Output
1 2
Merger
3 4 5 6 7 8 9 10
1 2
Merger
3 4 5 6 7 8 9 10
A B
Pro16Pro64
A-Net Systems Interface
1-16 17-32 33-48 49-64
The ASI is shown connected to Pro64 modules in series.